Determining How Much Power Your Speakers Need

 I have speakers rated at 200 watts RMS. Does that mean I need a 200-watt amplifier for each one?

The short answer: No.

A speaker’s RMS rating indicates how much power it can safely handle—not how much power it “needs” to operate. Let’s look at why.

Understanding Power Ratings

Speaker “RMS” Power Rating

The “RMS” (Root Mean Square) or “nominal” power rating tells you the continuous power the speaker can handle under normal conditions. A key factor behind this rating is the size of the speaker’s voice coil: larger coils can dissipate more heat, allowing the speaker to handle more power.

When choosing an amplifier, always match your speaker’s RMS power handling to the amplifier’s RMS output. For example, if your speakers are rated for 50 watts RMS each, look for an amplifier that can deliver around 50 watts RMS per channel.

Speaker “Peak” Power Rating

This is the maximum amount of power a speaker can handle for brief moments without damage. However, if the peak power limit is exceeded for too long, it can overheat the voice coil and damage the speaker.

Important: Never match your speaker’s RMS rating to an amplifier’s peak power output. That’s a common mistake.

For instance, if your speakers are rated at 50 watts RMS, using an amp that delivers 125 watts RMS per channel would likely overpower the speakers, risking burned or shorted voice coils.

How Much Power Do You Actually Need?

Back to the original question: Do you need a 200-watt amplifier for a 200-watt speaker?

No - you don’t need to provide the full 200 watts.

A 200-watt RMS speaker can still perform well with much less power—sometimes as little as 30% of its RMS rating (e.g., 60 watts). The trade-off is that with lower power, your maximum loudness (SPL, or sound pressure level) will be lower.

Sample Amplifier Power Rating Chart:

Amplifier Power Low Side (30% of RMS Power)

0.30 × (Number of Speakers × RMS Power Rating = Required Amplifier Power)

Amplifier Power High Side (RMS Power):

Number of Speakers × RMS Power Rating = Required Amplifier Power